![\"\"](\"http:\/\/parksandsonspiano.com\/intheshop\/wp-content\/uploads\/2017\/03\/piano_lid_768x1024.jpg\")
<\/a>The lid before stripping the finish (rear segment to the left)<\/p><\/div>\n
With some vertical pianos (with two piece lids), the rear segment can be removed. The rear segment of this particular model\u00a0McPhail piano is glued down, so repairs must be made in place.<\/p>\n
<\/a>Lid damage (finish removed)<\/p><\/div>\n
Some of the cracks are small enough as to not cause visual problems. The larger, darker cracks will need cleaning up and patching.<\/p>\n
We use a shop made cutting tip that allows us to carve a groove along the crack. The tool allows us to make the groove the correct width and depth for patching.<\/p>\n
<\/a>Cutting a groove along a crack<\/p><\/div>\n
Once the crack has been prepared we can cut a veneer patch to the correct length and glue it in.<\/p>\n
<\/a>Fitting a patch to the prepared crack<\/p><\/div>\n
<\/a>Patch glued in<\/p><\/div>\n
Once the glue dries we can trim and sand level.<\/p>\n
<\/p>\n
<\/a>Patch leveled flat<\/p><\/div>\n
A little paint thinner lets us see how it will look with a finish.<\/p>\n
<\/a>The raw patch, other awaiting work<\/p><\/div>\n
As can be seen, these patches will also need to be colored to match. With such\u00a0thin patches it is best to wait until the wood has received its first sealing coats before matching the colors.<\/p>\n
<\/p>\n
The piano also had some more sever veneer damage along the lower edges on each side.<\/p>\n
<\/a>Lower-left side veneer damage<\/p><\/div>\n
As with patching descriptions in previous posts, the first step is to find a portion of repair veneer closely matching the same grain patterns.<\/p>\n
<\/a>Making the tracing cut for the patch<\/p><\/div>\n
We\u00a0cut a tracing of the patch.<\/p>\n
<\/a>The area to patch after cleaning up the cuts<\/p><\/div>\n
Now we can clean up the area for patching. The substrate veneer was very damaged as well so we needed to make up a new substrate. The substrate is basically a layer of veneer that runs at a right angle to the surface veneer. Its purpose is to create a smooth flat surface and, very important, protect the surface veneer from wood movement (i.e. the swelling and shrinking of the cabinet wood).<\/p>\n
<\/a>Leveling the substrate<\/p><\/div>\n
Once the substrate is glued in we scrape the surface flat.<\/p>\n
<\/a>The new patches glued up and sanded (note the other smaller ones to the left)<\/p><\/div>\n
The new patch gets glued in. There was a need for a couple smaller patches as well (as seen on the photo above).<\/p>\n
<\/a>Graining in the patch<\/p><\/div>\n
Once the new patch is stained to match, we can begin graining in to help disguise the seem. Graining can also be used to help create effects for\u00a0better matching.<\/p>\n